• 
  
  ติดต่อลงโฆษณา [email protected] หรือโทร. 081-811-1138 หรืออ่านรายละเอียดเพิ่มเติม คลิกที่นี่

Name:

Verification:

Loading...

Message:

<p>[QUOTE=&quot;Artit Pungird, post: 2121551&quot;]Neon Trouble Codes 11 Intermittent loss of either camshaft or crankshaft position sensor,/No crank reference signal detected during engine cranking/Timing belt skipped 1 tooth or more from initial learned value, 12 Direct battery input to PCM was disconnected within the last 50 key-on cycles 13 No change in MAP from start to run 14 MAP sensor voltage too low 15 No vehicle speed sensor signal 17 Closed loop temp not reached or engine cold too long 21 02 sensor problem (oxygen sensor), upstream or down stream 22 Engine coolant temp sensor out of range 23 Intake air temp sensor out of range 24 Throttle Position sensor out of range 25 Idle air control motor circuitstarget idle not reached (+/- 200),vacuum leak found 27 Injector control circuit 31 Evap purge flow monitor failure or evap solenoid circuit 32 EGR system failure 33 A/C clutch relay circuit 34 Speed control Solenoid circuits 35 Rad Fan control relay circuit 37 Torque converter clutch solenoid circuit or park/neutral switch failure 41 Generator field not switching properly 42 Fuel pump relay control ckt, Auto shutdown relay control ckt, No ASD relay output voltage at PCM, Fuel level sending unit volts out of range 43 Multiple/ single cylinder misfire 44 Battery temp sensor volts out of range 46 Charging system voltage too low 51 Fuel system lean 52 Fuel system rich 53 Internal control failure 54 No Cam signal at PCM 55 End of error messages 62 PCM failure SRI mile not stored 63 PCM Failure EEPROM write denied 64 Catalytic Converter Efficiency Failure 65 Power steering switch failure[/QUOTE]</p><p><br /></p>

• Log in with Facebook
• Log in with Twitter
• Log in with Google

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in